T-110 Dupli-Carver 222 1st Avenue NW • Watertown, SD 57201 Phone: (605) 882- 3888 • Fax: (605) 882 -0778 Email: infoterrcocom • Website: wwwterrcocom Table Material 1- 1/8” Particle Board Table Size 23” x 12” x 1 - 1/8” Work Area 2’ x 4’ Pivot Arms 1- 1/2” x 1/8” Forged Steel Pivot Bearings Sleeve Bearings Router Guide Shaft 1/2” Steel Shaft Bearings Delron Table Legs High Impact ABS Steel Finish Baked Enamel Carving Capacity 8” Dia x 18” Tall Spindle Capacity 8” Dia x 30” Long Weight 37 lbs Carton Size 27” x 22” x 2 - 1/2” Our Model T-110 Dupli-Carver is designed to fill the needs of a hobbyist or craftsman with the same accuracy and versatility of our professional models The T-110 is a lighter machine and used on a table, bench or stand and requires a work area of only 2’ x 4’ The machine sits on skid resistant rubber feet under the leg base boards so the machine will not slide or damage your bench surface The T-110a Spindle Carver expands the capabilities of the T- 110 to 30” long by 8” diameter The carriage consists of a set of tubes that slide through the table legs and cross members that support the work pieces in a horizontal position Table legs, candle holders and gunstocks are easily and accurately carved with this accessory Both turn tables are linked together so that the objects rotate in unison through 360 ° The carriage slides forward and back to allow you to carve the entire 30” length without remounting the work piece Comes complete with operating instructions and all assembly hardware T-110a Spindle Carving Option